Faucet & Fixture Installation in Greenville, South Carolina

Faucet and fixture installation in Greenville typically runs $143–$570 in labor (national $150–$600 adjusted roughly 5% below national average) plus the fixture cost. A kitchen faucet swap on a functioning shutoff valve is $150–250 labor; a bathroom faucet is $100–200; a shower valve and trim kit runs $250–600 depending on access. Bring your own fixture or let the plumber source one — just confirm it's lead-free certified (required since 2014).

Supply line braided hoses should be replaced every 5–7 years regardless — a $12 part that fails can cause significant water damage. The matched plumber includes new supply lines as part of every faucet installation.

A straight like-for-like faucet swap (same position, same connection type) does not require a permit in Greenville under SC LLR. Moving a faucet location, adding a new sink, relocating a shower valve, or installing outdoor hose bibs typically does require a permit. The matched plumber confirms permit requirements during the scheduling call and pulls any needed permits on your behalf.

Greenville's 2 gpg water is very soft, which is mildly corrosive to chrome — a quality ceramic disc valve and periodic aerator cleaning keeps fixtures running well. Any standard lead-free faucet from a major manufacturer works well in Greenville water.

Yes — the Reduction of Lead in Drinking Water Act (2014) requires all potable-water faucets sold or installed in the US to contain no more than 0.25% lead in wetted surfaces. This applies to every replacement faucet installed by a licensed plumber in Greenville. Non-compliant faucets (often gray-market imports without NSF 61/372 certification) can leach lead into drinking water. The matched plumber sources only compliant, NSF-certified fixtures.

Three types: (1) compression (rubber seat that tightens against a valve seat — common in older Greenville homes, requires periodic stem replacement, the "replace the washer" fix); (2) ball valve (single-handle, stainless ball with ports — high-flow but seal-prone in hard water); (3) ceramic disc (single or double lever, nearly maintenance-free, industry standard since the 1990s). In Greenville's water, ceramic disc is a proven long-term choice for most applications.

A standard kitchen faucet replacement on accessible, functional shutoffs takes 45–90 minutes. Bathroom faucets run 30–60 minutes. Shower valve and trim take 60–120 minutes if the valve body is accessible from the front; add time if tile must be cut or access panel installed. Most AlertPlumber-matched plumbers in Greenville book faucet work within 1–2 business days; it's rarely urgent unless the existing fixture is spraying.

Kitchen faucets typically require reach into a confined sink-base cabinet with spray-hose connections — tight space work. Bathroom faucets involve a pop-up drain assembly that frequently seizes in older fixtures. Shower valves are the most complex: the valve body is behind the wall (requires cutting or an existing access panel), must be pressure-balancing (required by code in Greenville to prevent scalding), and requires matching trim to the existing rough-in brand and spacing.

DIY is reasonable for: a kitchen or bathroom faucet swap where existing shutoffs work, supply lines are accessible, and no soldering is needed — most modern faucets use push-fit or braided supply connections. Call a plumber for: shower valve replacement (wall access + pressure-balance code), any fixture requiring soldered connections, shutoff valve replacement, or if the existing supply lines are corroded or stuck. Licensed work in Greenville (SC LLR) is required for any new supply-line run or drain modification.

Yes. Every plumber matched through AlertPlumber for faucet and fixture work in Greenville holds an active SC LLR license. Most faucet installations complete in a single visit — the matched plumber carries common cartridges, supply lines, and shutoff valves for the most frequent repair-alongside scenarios.